Synthetic Route of 13395-16-9, One of the major reasons for studying chemical kinetics is to use measurements of the macroscopic properties of a system, such as the rate of change in the concentration of reactants or products with time.Mentioned the application of 13395-16-9.
Line-beam scan irradiation for preparation of YBCO films with high-Jc by excimer-laser-assisted MOD (ELAMOD)
Preparation of epitaxial YBa2Cu3O7 (YBCO) films on cerium oxide-buffered sapphire (r-cut alpha-Al2O3) substrates by an excimer-laser-assisted metalorganic deposition (ELAMOD) is reported. The ELAMOD process has been developed to bring about the advantage of shorter heating time than that in the conventional metalorganic deposition; the coated films are irradiated by an excimer laser beam before firing. We initiated the ELAMOD-YBCO process using a homogenized 8-mm-square laser beam which irradiates the coated surface in a fixed substrate mode. In order to extend the process applicable to large-area films, a scan irradiation mode was employed and a high critical-current density over 6 MA/cm2 has been observed. In the process, an appropriate choice of laser energy is difficult but crucial to obtain YBCO films with high superconducting properties. Then, laser irradiation from backside of the substrate was examined and proved to be beneficial to extend the experimental window of the laser energy. Moreover, a newly developed ELAMOD process using a 90-mm-wide line-beam is also reported which has a potential ability for large-area applications.
Sometimes chemists are able to propose two or more mechanisms that are consistent with the available data. Synthetic Route of 13395-16-9, If a proposed mechanism predicts the wrong experimental rate law, however, the mechanism must be incorrect.Welcome to check out more blogs about 13395-16-9, in my other articles.
Reference£º
Copper catalysis in organic synthesis – NCBI,
Special Issue “Fundamentals and Applications of Copper-Based Catalysts”